Go Back   The Quad4Forums > Search Forums
Showing results 1 to 25 of 45
Search took 0.01 seconds.
Search: Posts Made By: #17RaceTeam
Forum: 2.3l Quad 4 General Discussion 04-11-2017, 11:30 PM
Replies: 4
Views: 561
Posted By #17RaceTeam
I may have a set and am parting out a beretta or...

I may have a set and am parting out a beretta or three and a grand am soon. Is the beretta the same length? Check the part numbers and pm me.
Forum: Member Rides 01-28-2017, 09:47 PM
Replies: 29
Views: 2,540
Posted By #17RaceTeam
Sent a personal message. I'm in Pennsylvania.

Sent a personal message. I'm in Pennsylvania.
Forum: Member Rides 01-27-2017, 10:14 PM
Replies: 29
Views: 2,540
Posted By #17RaceTeam
I happen to have a complete 92 parts car that...

I happen to have a complete 92 parts car that needs to go. Gotta make room for beretta parts cars, not olds. I pulled the engine and tranny for racing spares but would consider selling the car and...
Forum: 2.3l Quad 4 Problems 11-04-2016, 09:01 PM
Replies: 11
Views: 1,226
Posted By #17RaceTeam
I would definitely look at fuel first. Clean it...

I would definitely look at fuel first. Clean it out from injectors to the tank.
Good luck!
Forum: 2.3l Quad 4 Problems 11-03-2016, 06:35 PM
Replies: 11
Views: 1,226
Posted By #17RaceTeam
Why a fuel flush? Was it running rough before the...

Why a fuel flush? Was it running rough before the flush?
The flush may have clogged something up causing a lean condition which could burn off spark plugs. I would flush the entire fuel line from...
Forum: 2.3l Quad 4 General Discussion 10-22-2016, 07:08 PM
Replies: 6
Views: 1,487
Posted By #17RaceTeam
Sure you will, I lurk on here all the time....

Sure you will, I lurk on here all the time. Mostly reading you and Biz banter along, good stuff. Actually just used another head I had on the shelf. I started to make a plate for pressure testing...
Forum: 2.3l Quad 4 General Discussion 04-27-2016, 07:52 AM
Replies: 0
Views: 584
Posted By #17RaceTeam
spring thing

Last week I had a clutch finger break off causing some carnage in the bellhousing. Putting it back together noe but the spring thing on the throw out bearing is shot. Can I go without it? I can't...
Forum: 2.3l Quad 4 General Discussion 04-19-2016, 05:33 PM
Replies: 7
Views: 1,148
Posted By #17RaceTeam
Odds are the area where the rings sat are too...

Odds are the area where the rings sat are too rusted but you can hone it first to see if they will hone out. Probably will need bored over then oversized pistons. Cha ching. Where else can you find...
Forum: General Car Chat 02-23-2016, 07:03 AM
Replies: 21
Views: 2,705
Posted By #17RaceTeam
Ditto on Coopers. I mostly ran their winter tires...

Ditto on Coopers. I mostly ran their winter tires but good grip. Ditto on the winter/summer switch also. We try to keep sets mounted up with each so the switch is easy. Wear and grip is a delicate...
Forum: General Car Chat 01-11-2016, 09:16 PM
Replies: 28
Views: 2,885
Posted By #17RaceTeam
The q4 crowd is most likely dwindling so a...

The q4 crowd is most likely dwindling so a expanding population may be difficult. It is a very specialized engine, not a wide range of years produced, and the younger crowd, who knows.

Sounds like...
Forum: General Car Chat 01-11-2016, 05:18 PM
Replies: 28
Views: 2,885
Posted By #17RaceTeam
But where will biz and 086 banter back and forth?...

But where will biz and 086 banter back and forth?
Realistically I am willing to ante up more to keep it afloat. I have received way more in live advice and research that I have put in. Plus I don't...
Forum: Site Polls 12-21-2015, 10:28 PM
Replies: 16
Views: 4,747
Posted By #17RaceTeam
Not into the gold or white. Something chrome or...

Not into the gold or white. Something chrome or polished aluminum. But you have to live with her...the girlfriend and the car.
Forum: 2.4l Twin Cam Performance 12-11-2015, 07:04 AM
Replies: 8
Views: 1,497
Posted By #17RaceTeam
I would take it to your local machine shop. Had a...

I would take it to your local machine shop. Had a stock one done recently. Got it down to about 9.5 lbs.
Forum: New Member Intros 10-11-2015, 02:04 PM
Replies: 4
Views: 723
Posted By #17RaceTeam
Welcome to the wild world of quad four racing. I...

Welcome to the wild world of quad four racing. I run a 2.3 beretta on dirt in PA. Go for it but most of all keep it fun. Pull it on the trailer running and in one piece. Its the most frustrating fun...
Forum: 2.3l Quad 4 General Discussion 08-10-2015, 10:45 PM
Replies: 3
Views: 1,149
Posted By #17RaceTeam
Update for anyone attempting this. I heated the...

Update for anyone attempting this. I heated the gear to 400 in the family oven and froze the crank in the deep freeze. The gear slid on to within 1/16 then stopped. I tried pressing it the rest of...
Forum: 2.3l Quad 4 General Discussion 07-11-2015, 02:10 PM
Replies: 3
Views: 1,149
Posted By #17RaceTeam
Thanks, thought that might be the answer.

Thanks, thought that might be the answer.
Forum: 2.3l Quad 4 General Discussion 07-11-2015, 09:31 AM
Replies: 3
Views: 1,149
Posted By #17RaceTeam
oil pump drive gear

Is it possible to remove an oil pump drive gear from the crank and reinstallit on a new crank? It doesn't look easy with puller or heat. New gears are 50 bucks plus shipping which isn't too bad....
Forum: General Car Chat 06-29-2015, 10:49 PM
Replies: 1
Views: 636
Posted By #17RaceTeam
1992 scx

http://cincinnati.craigslist.org/cto/5072368321.html

Has anyone seen this one? Hate to see it dissappear.
Could it be one of the forum members?
Forum: General Car Chat 06-29-2015, 07:48 PM
Replies: 5
Views: 724
Posted By #17RaceTeam
The gentleman was to call me back last week but...

The gentleman was to call me back last week but of course did not. I'll try to get in touch with him tomorrow and ask the questions at hand.
Forum: General Car Chat 06-23-2015, 11:18 PM
Replies: 5
Views: 724
Posted By #17RaceTeam
Yep, have all that info In my quad four stack. I...

Yep, have all that info In my quad four stack. I am only looking for the newer version also. I'll let you know.
Forum: General Car Chat 06-22-2015, 10:45 PM
Replies: 5
Views: 724
Posted By #17RaceTeam
remanufactured crankshafts

Is anyone interested in buying remanufactured crankshafts for a 2.3? I came across a company going out of business. They have four of them. If I buy all four they will be 100 bucks each plus...
Forum: 2.3l Quad 4 General Discussion 04-26-2015, 08:39 PM
Replies: 6
Views: 1,487
Posted By #17RaceTeam
Probably, haven't found anything by inspection. ...

Probably, haven't found anything by inspection.

I did have a friend/old school mechanic and he suggested filling the coolant passages with gas. Gas will seep through almost any crack according...
Forum: 2.3l Quad 4 General Discussion 04-25-2015, 02:06 PM
Replies: 6
Views: 1,487
Posted By #17RaceTeam
Next quad 4 frustration!

Have a freshened up engine. Ran it a few times, ran good, 60-80 lbs oil pressure, everything was looking good. ARP head studs and home made cam studs. Went o run it again yesterday and checked the...
Forum: 2.4l Twin Cam Problems 03-13-2015, 09:58 PM
Replies: 3
Views: 1,342
Posted By #17RaceTeam
Found this site, looks handy. Some other tests on...

Found this site, looks handy. Some other tests on there that may be related to your problem.
Good luck!

http://easyautodiagnostics.com/gm/2.4L/how-to-test-the-ignition-coils-1
Forum: 2.3l Quad 4 General Discussion 02-18-2015, 09:05 AM
Replies: 0
Views: 493
Posted By #17RaceTeam
Flywheel cover

Looking for a flywheel cover. Reply if you have one to spare and the cost.
Thanks
Showing results 1 to 25 of 45

 
Forum Jump

All times are GMT -4. The time now is 04:11 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright (C) quad4forums.com